GL Veneer Alder Wood Veneer Sheet, Clear Plain Sliced, PSA Backed, 24 in. x 96 in.

This is a plain sliced alder wood veneer sheet with a PSA (pressure sensitive adhesive) backing, sold as one 24 in. x 96 in. sheet. The veneer shows a pinkish-brown to nearly white color with straight grain and a moderately fine, uniform texture. Apply it to a smooth substrate such as MDF or particleboard for cabinet faces, panels and millwork.

Key Features:

• PSA peel-and-stick backing: The pressure sensitive adhesive backing lets you position the sheet and press it into place without separate contact cement.
• Warm alder tone: Color ranges from pinkish-brown to an almost white shade across the leaf.
• Uniform straight grain: Plain sliced alder offers straight grain with a moderately fine, even texture.
• Natural character marks: The species is prone to character-building defects such as pin knots and open knots.
• Sourced region: This alder grows in the Pacific Northwest, including Oregon, Washington, California and British Columbia.
• Large workable sheet: The 24 in. x 96 in. size covers long panel runs and door faces with few seams.

Specifications Table:

Coverage & How Much You Need:

One sheet covers 24 in. x 96 in., or 16 square feet of flat surface before trimming waste. Plan layout so grain direction runs the length of your panels and allow trim allowance at each edge.

Fit and Compatibility:

Designed for bonding to smooth, sealed substrates such as MDF, particleboard or plywood using its PSA backing. Stain, clear coat and edge banding are sold separately; alder accepts finishes typical of the species.

Frequently Asked Questions (FAQ):

Q: What is included with this sheet?
A: One 24 in. x 96 in. plain sliced alder veneer sheet with pressure sensitive adhesive backing. Adhesive primer, edge banding and finishing products are sold separately.

Q: How much area does one sheet cover?
A: One sheet covers 16 square feet (24 in. x 96 in.) before trimming waste, enough for cabinet door faces or a long panel.

Q: How do I install a PSA-backed veneer sheet?
A: Roll it onto a clean, smooth, dust-free substrate, align the leading edge, then peel and press progressively while smoothing from the center outward with a veneer hammer or roller.

Q: What substrate should I use?
A: A stable, smooth substrate such as MDF or quality particleboard is recommended; a backer sheet on the opposite face helps prevent warping.

Q: Will the color and grain vary between sheets?
A: Yes. Alder ranges from pinkish-brown to nearly white and often carries pin knots and open knots, so character will vary sheet to sheet.

Q: Can I cut the sheet to size?
A: Yes, trim with a sharp utility knife or a fine-tooth saw blade, cutting slightly oversized and sanding to the final line.

Expert Verdict — Reviewed by the SuperArbor Pro Desk

PSA-backed alder is a good pick for small shops because it eliminates contact adhesive and its fumes, but it bonds best to very smooth, sealed MDF or particleboard. Always apply a balancing backer or veneer to the reverse face of the substrate to keep panels flat. Trim slightly oversized and flush-trim after the sheet has fully adhered, and seal all cut edges before staining.

Use a sharp blade when trimming veneer and keep hands clear of the cut line; wear gloves and eye protection when cutting and sanding.

Order the GL Veneer Alder Veneer Sheet today for warm, straight-grained alder surfacing on your next cabinet or millwork project.