Skip to content
ACM Galvanized Roof-to-Wall Angle Flashing, 26 Gauge, 4 in. x 6 in., 110 Degree, Mill
Regular price $32.50Orders start at $399 — combine any items to reach the minimum. Learn more
ACM Galvanized Roof-to-Wall Angle Flashing, 26 Gauge, 4 in. x 6 in., 110 Degree, Mill
ACM Roof to Wall Flashing 110 Degree is a 26 gauge galvanized steel angle flashing formed at 110 degrees to bridge the joint where a roof plane meets a wall. This line has one item: 4 in. x 6 in. legs in mill finish, sold per piece. Use it wherever the roof-to-wall angle calls for the 110 degree bend.
Key Features:
- 110 degree angle: Formed at 110 degrees to seat against the roof-to-wall intersection.
- 26 gauge steel: Made from 26 gauge galvanized steel.
- 4 x 6 legs: 4 in. x 6 in. leg configuration for standard roof-to-wall coverage.
- Mill finish: Mill galvanized finish, suitable for exposure or painting.
- Angle flashing: Functions as angle flashing to shed water at the wall junction.
- Per piece: Sold individually by the piece.
Specifications Table:
| Specification | Details |
|---|---|
| Brand | ACM |
| Sell unit | 1 piece |
| Product line | ACM Roof to Wall Flashing 110 Degree |
| Available sizes | 4 in. x 6 in. |
| Material | Galvanized steel |
| Finish / texture | Mill |
| Thickness | 26 ga |
| Dimensions | 4 in. x 6 in., 110 degree angle |
| Intended use | Angle flashing at roof-to-wall intersections |
Coverage & How Much You Need:
Each piece covers the linear length of one roof-to-wall junction section; order enough pieces to run the full wall length with appropriate laps.
Fit and Compatibility:
Pairs with shingle courses and base or step flashing at wall junctions. Underlayment, sealant and fasteners are sold separately.
Frequently Asked Questions (FAQ):
Q: What is included?
A: One 26 gauge galvanized 110 degree angle flashing, 4 in. x 6 in., mill finish.
Q: When is a 110 degree angle correct?
A: Use it where the roof pitch meets the wall at approximately 110 degrees so both legs seat flat.
Q: How is it installed?
A: Set the angle over the roof-to-wall joint with the up-leg against the wall and the down-leg lapping the roof, then fasten and seal per standard practice.
Q: Is the finish paintable?
A: Yes, mill galvanized steel can be painted after proper surface preparation.
Q: How many pieces do I need?
A: One piece per section of junction; compute the wall run and allow laps between pieces.
Expert Verdict — Reviewed by the SuperArbor Pro Desk
Verify the actual roof-to-wall angle before ordering; a 110 degree formed flashing only seats correctly on matching geometry, and flat stock may serve odd angles. Lap successive pieces and keep the up-leg protected behind siding or counter flashing.
Galvanized sheet edges are sharp; wear gloves and eye protection during handling and cutting.
Order the ACM 26 gauge 110 degree roof-to-wall flashing for your next wall junction.
All third party trademarks, including logos and icons, referenced on our website and product pages remain the property of their respective owners. Unless specifically identified as such, Arbor's use of third party trademarks does not indicate any relationship, affiliation, sponsorship, or endorsement between Arbor Home and the owners of these trademarks. Any references by Arbor Home to third party trademarks are to identify the corresponding third party goods.
